Bug: while selecting multiple citations
While in a word processor:
Click the icon to insert a citation.
Zotero gets the RPC and throws up a selection dialog.
Click "Multiple Sources . . ."
Select an item and click right arrow to add it to the right-panel.
Change your mind and decide you don't want it.
Click left arrow to remove it from the list.
Change your mind again and decide you want it on the list after all, but . . .
Select the same item again and you cannot add it to the right panel.
I found this using Word, but since it's on the Zotero side, it will affect any word processor plug in.
Click the icon to insert a citation.
Zotero gets the RPC and throws up a selection dialog.
Click "Multiple Sources . . ."
Select an item and click right arrow to add it to the right-panel.
Change your mind and decide you don't want it.
Click left arrow to remove it from the list.
Change your mind again and decide you want it on the list after all, but . . .
Select the same item again and you cannot add it to the right panel.
I found this using Word, but since it's on the Zotero side, it will affect any word processor plug in.
This is an old discussion that has not been active in a long time. Instead of commenting here, you should start a new discussion. If you think the content of this discussion is still relevant, you can link to it from your new discussion.
Also, I can not add more than three citations in a single bookmark. I get two kinds of error messages:
"An error occurred while communicating with Zotero. Please ensure Firefox is open and try again" (And yes, firefox was open)
Or
'run time error 5: invalid procedure call or argument'.
I'm not sure what causes which error message to occur. All I know that if I put three citations, it's fine, but no more than that.